Discuss, share information, ask questions, and show off your expertise on Yoder Pellet Cookers.

Click the links below to go directly to available resources:
**Pellet cookers** - YS480, YS640
**Competition Pellet cookers** - YS480 Comp, YS640 Comp, YS1500 Comp, Cimarron Comp
**Pellet Cooker Warranty**
April 14th, 2019, 3:27 pm
#1
* Abilene ** Abilene *
  • Joined: August 4th, 2016, 6:27 pm
  • Posts: 2

Hello all, after many great cooks on my ys640 I am having problems with tripping the GFCI. I am going to do a manual lighting test tomorrow to verify that the igniter is my problem. Question I have is should I replace the thermocouple at the same time as the igniter? Saw an online post that recommended replacing both if replacing one.

Thanks for any recommendations!!!

WamegoQ

April 14th, 2019, 3:55 pm
#2
* Wichita ** Wichita *
  • Joined: July 25th, 2015, 1:21 pm
  • Posts: 145

Personally, I wouldn't. The two are independent of each other and really do not take long to replace. In my mind its kinda like replacing both headlights on your car when one goes out...even though one has reached the end of its lifespan does not necessarily mean the other is gunna go anytime soon.
I would however order a thermocoupler if you do not have one on hand as there is nothing worse than blowing one and being without when it is only a 20 minute fix.

April 14th, 2019, 8:49 pm
#3
Site AdminSite Admin
User avatar
  • Joined: April 18th, 2014, 3:12 pm
  • Posts: 2408

We at the Yoder Smokers factory have never stated that both the igniter and thermocouple should be replaced at the same time. They are completely separate systems and have nothing to do with each other. There are a lot of self proclaimed "experts", but if you need Yoder Smokers factory help, contact us at 877.409.6337, option 2, or send us email at [email protected].

If either the thermocouple, or the igniter, have failed, just replace the part that has failed.

Keeping a spare thermocouple is a popular thing to do, so if you have a cook and find that the thermocouple is bad, you can immediately replace it, as the cooker will not function without a working thermocouple.

Some people also keep a spare igniter, but this is not necessary, as you can always follow the instructions in the owners manual on hot to manually light the cooker.

Yoder_Herb
April 15th, 2019, 4:14 pm
#4
* Abilene ** Abilene *
  • Joined: August 4th, 2016, 6:27 pm
  • Posts: 2

Thanks guys!! I got it to light normally today and did a burn out of the grease, etc that had built up from winter cooks. It burned along great at 500 for about 45 minutes and then tripped the GGCI. I unplugged and tried to relight twice but tripped the outlet again after only a few seconds. At least I got the burn out done. Ordering a couple of igniters and a thermocouple spare today. Still the best cooker in my opinion. Thanks again for the insight.

Return to Pellet


cron