Hi Folks,
I’m performing a S Series Upgrade on a “new to me” 2018 YS640 and I picked up a YS Series High Flow Pellet Burn Grate when I was doing the Ceramic Igniter. Now my question is a what am I missing/ doing wrong one in that the new burn grate is not sitting flush against the hopper wall.. there is about a half inch gap.. the old grate sits flush..
Thoughts? Likely operator error but I can’t see how and from reading here, said gap is a fire hazard..
Have you attempted to reshape the burn grate by placing it open face down on a hard surface and stepping on it? Make sure to check fitment after a couple attempts to get the best fit.
I have not as it is brand new and per Yoder/Atbbq’s product description page it should work in the YS640
Bend wise the upgraded grate is identical to the older save that it is shorter..
I’ll add images shortly
- Disclaimer :
- The views and comments entered in these forums are personal and are not necessarily those of the management of this board.
