YS 480 Temp Probe different location??
Posted: March 16th, 2015, 8:41 pmHey All,
I just received my new YS480, tonight and I'm ready for this weekend and many cooking adventures to come.
Looking over the grill and pictures in the operation instructions I did notice a change.
**In my new grill- the temperature probe/thermocoupler is above the heat diffuser but just to the side area of the burn grate\fire box....almost over it
##The older models had the temperature probe\thermocouple on the back side of the grill above the heat diffuser.
1. Why the change in location?
2. When I do direct grilling\searing.....will this give the coupler a higher temperature reading being over the burn grate\fire box without the heat diffuser covering it?
3. This new location(almost above the diffuser and directly over the fire box-but covered by the diffuser) will it give a higher reading in general then when it was located on the back side?
Again as not to confuse anyone.
New location: Temp. probe above the diffuser but almost over the area of the fire box......not the location where it use to be on the back side.
*** Not this ....mine is close to the single screw on the far left.***
Thanks!!
I just received my new YS480, tonight and I'm ready for this weekend and many cooking adventures to come.
Looking over the grill and pictures in the operation instructions I did notice a change.
**In my new grill- the temperature probe/thermocoupler is above the heat diffuser but just to the side area of the burn grate\fire box....almost over it
##The older models had the temperature probe\thermocouple on the back side of the grill above the heat diffuser.
1. Why the change in location?
2. When I do direct grilling\searing.....will this give the coupler a higher temperature reading being over the burn grate\fire box without the heat diffuser covering it?
3. This new location(almost above the diffuser and directly over the fire box-but covered by the diffuser) will it give a higher reading in general then when it was located on the back side?
Again as not to confuse anyone.
New location: Temp. probe above the diffuser but almost over the area of the fire box......not the location where it use to be on the back side.
*** Not this ....mine is close to the single screw on the far left.***
Thanks!!