Yoder Smokers Community Forum

Good morning. I purchased a ys640 back in 2019 from attbbq and i just recently did a full clean, gasket replacement, etc to it. I just got it all back together and i am noticing that my lid just doesn't seem to seal correct. I did add the front grease shield which i didint have on before but that shouldn't make a difference. I put the gasket on just like it was before, cleaned it well before applying etc. Also i do already have the shims on this grill so i didint need to add those, unless there is supposed to be 2 shims?

I am attaching some pics of what i am noticing on both sides for reference.

I'm not sure what to do....






Thanks in advance

any insight here or thoughts?