ACS Upgrade + new temp probe.

matchrocket

* Abilene *

• Joined: July 17th, 2016, 1:37 pm
• Posts: 2

ACS Upgrade + new temp probe.

I upgraded my YS480 to the ACS controller and replaced my temp probe while I was at it as it was broken.

After I got everything installed and fired up, the two external probes have a 35 deg offset to my Pit probe.

The PIT probe is INCORRECT vs the external probes, I verified it with a my normal pit vs food monitor I used to use.

I know I can do a calibration (Read the posts) but good lord, this offset is massive. I am starting to think my new probe is Dead on Arrival..

Anyone else see an offset this big before between pit and external probes on the acs?

[Yoder_Herb]

Yoder_Herb

Site Admin

• Joined: April 18th, 2014, 3:12 pm
• Posts: 2408

• Website

Re: ACS Upgrade + new temp probe.

Here is the calibration process: http://community.yodersmokers.com/viewt ... =73&t=2033

If you need more help, please contact us directly at [email protected] so we may properly help.